Fabdec Excelsior WDE with External Expansion Direct Cylinder

BBA approved, the Fabdec Excelsior WDE Direct External Expansion Cylinder water heaters do not require a header tank so can be sited anywhere on the property, subject to suitable plumbing and water pressure. A minimum requirement of 1.5 bar pressure and 15 litres per minute flow is suggested for satisfactory operation – although most homes in the UK now have pressure of more than 2 bar.
Features and benefits:
- Improved packaging to offer benefits with compact installation spaces
- Immersion heater, temperature and pressure valves insulated for added reduction in heat loss
- Green recycled materials used for outer casing
- 3 bar pressure at outlets (subject to adequate incoming pressure)
- All sizes WRAS approved
- Cylinder guaranteed for 25 years
- Duplex stainless steel so no sacrificial anode is needed, reducing maintenance
- UK designed and manufactured allowing for local support, spares and service back up
- Corrosion is eliminated with butt welded joints, giving you a longer cylinder life
- Inlet diffuser to maximise hot water
- High performance heating coil gives fast re-heat times and constant hot water
- 60mm insulation with outer casing minimises heat loss resulting in lower energy use
- High flow rates allow for fast filling baths with no shower pumps required
- Mains pressure to all outlets gives balanced hot and cold water for high performance showering
- Pre-plumbed cylinders available allowing ease of installation and minimal disruption to the consumer
- Twin or triple coil available, suiting all heat sources - useable with solar or heat pumps

Further technical information stated below